In BoB-test, we use a fictitious PTA called Centertrafiken which has a zone map over a number of zones. There are stop areas with local numbers. In the north there is a neighboring PTA called Norrtrafiken for test cases covering cross county travel.
| Gliffydrawio | ||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
...
|
Product categories
The following product categories are available:
singleTrip
dayPass
monthlyPass
Traveller categories
The following traveller categories are available:
a (adult (id: a)
youth (id: h)
Fare categories
...
)
b (retiree)
Is older that 65 years of age. Proved by an identity document.
Is an early retiree. Proved by a retirement certificate and an idendity document.
e (student)
Is between 18 and 50 years of age. A valid student card and an identity document is needed as proofs that the traveller are entitled to a student discount.
h (youth)
Is between 0 and 18 years of age. An identity document is needed as proof of age.
Transport mode and fare class
All products have transport submode, e.g. localBus or regionalTrain.
Bus products do not have to any fare class.
A single train product has fare class firstClass or secondClass.
A single train product has higher fare than buses on the same route, i.e. the same zone validity.
Transport mode and fare class must written in the MTB. An inspector must be able to se both the transport mode and fare class upon inspection or validation. Also, during automatic offline validation, the barrier validator must be able to read the transport mode and make a decision to let the passenger through or not.
Local bus
transportMode: ‘bus’
transportSubmode: ‘localBus’
Express bus
transportMode: ‘bus’
transportSubmode: ‘expressBus’
Train
transportMode: 'train'
transportSubmode: ‘regionalTrain’
fareClass: firstClass or secondClass with different fares
Fare categories
There are no fare categories available. Fare categories were deprecated in BoB Product v3 when generic categories were introduced.
Generic categories
These are the generic categories.
Generic category name | Generic category value | |
|---|---|---|
transportMode | bus | On product for all zones |
rail | On products for trips through zones 1, 2, 3 and N. | |
transportSubmode | localBus | On bus products for zone 1 exclusively. |
regionalBus | On bus products for all zones | |
expressBus | On bus products for trips through zones 1, 2 and 3. | |
fareClass | firstClass | On rail products. |
secondClass | On rail products. |
Since fare class is not applicable on bus trips there have to be separate product templates for bus and rail.
Fares
Single trip
Trips within 1 zone is 30 SEK for adult and 20 SEK for youth.
...
A day pass is valid for 24 hours.
A montly monthly pass is valid for 30 days.
...
There are a few product properties available for certain products:
bike
Product property bike is available for products with the following configuration:
...
product category: ‘monthlyPass’
zones: ‘1', ‘2’, ‘3’ and 'N’
traveller category: 'a'
Allowed values are: large and small
hamburger
Product property hamburger is available for products with the following configuration:
product category: ‘dayPass’
zones: ‘1', ‘2’ , and '3’
traveller category: ‘a' or 'h’
Allowed values are: meat and veggie
herringAndSnaps
Product property herringAndSnaps is available for products with the following configuration:
product category: ‘dayPass’
zones: ‘1', ‘2’ , and '3’
traveller category: ‘a'
Available values are:
Allowed value is large